Not been out as much as I'd of liked through other issues and such. Iv not bonded with any rifle since her if i tell the truth rezĪtvbjimmy :thumbs: Yeah super mate. Had some good hunting nights out with her rez she may have been not much to look at but feck was she accurateĭont think any thing has come close to her since not even my hw100,s(yes harry i had two hw100s) Seriously it amazed me the forays I saw with your raider. I do keep them a little more silicon lubed than normal, and as I've been doing that (and keeping them in a clean dust free container) I've not cut or blown an o-ring.Your right me old. Have been using my Pneuma fill probe and the Webley one interchangeably.either works fine with either gun. Look down the set screw hold and rotate the barrel until you see the white mark, then put in the set screw (and tighten the rear one).Īlthough marked for Hatsans, they work with the Hatsan made Raiders (the gun will have "Made in Turkey" on the left side plate): Put a touch of liquid paper white on the front set screw detent on the barrel. There is no indext mark, so completely take out the front set screw. HINT for putting the barrel back on right. Set screws are way-way short little buggers that have to go down quite aways to contact the little detents on the barrel. The barrel is not interlocked to the transfer port.so if the set screws really aren't locking down, would be able to pull the barrel out of the receiver (barrel is o-ringed). The good news (if this is a new Raider) is that the Pneuma/Hatsan sized o-rings work (in fact, the fill probe from a Pneuma works.probably identical as Hatsan made the last Raiders). At least for the short term, if you can find a set that works locally, use them.but order a set. Not sure hat size the 0-ring are, but lube them with silicon grease (and store the probe in an old, clean pellet tin).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
March 2023
Categories |